Product ID:OCEAN FLAYMBAR 477 FIRE RETARDANT EPOXY PAI
MSDS Date:03/01/1992
FSC:8010
NIIN:00-228-0649
Kit Part:Y
MSDS Number: BPNXH

OCEAN COATINGS, INC

5364 PAN AMERICAN FREEWAY
ALBUQUERQUE, NM 87109
US

Emergency Phone: 800-877-3473/800-424-9300 CHEMTREC

Info Phone: 800-877-3473

Cage: OCEAN

OCEAN COATINGS, INC.

245 SAVANNAH, GA 31402 US

Telephone: (912) 234-1236

Cage: OCEAN

DIGLYCIDYL ETHER/BISPHENOL A

CAS: 25068-38-6

RTECS: KC2100000

Fraction By Weight: 25-30%

DIBUTYL PHTHALATE (SARA III)

CAS: 84-74-2

RTECS: TI0875000

Fraction By Weight: 5-8%

OSHA PEL 5 PPM

ACGIH TLV: 5 PPM

EPA Report Quantity: 10 LBS

DOT Report Quantity: 10 LBS

PROPYLENE GLYCOL METHYL ETHER ACETATE

CAS: 108-65-6

RTECS: AI8925000

Fraction By Weight: 3-5%

ACGIH TLV: 100 PPM RECOMMENDED

HEAVY AROMATIC SOLVENT NAPHTHA

CAS: 64742-94-6

Fraction By Weight: 13-17%

ACGIH TLV: 100 PPM RECOMMENDED

PROPYLENE GLYCOL METHYL ETHER

CAS: 107-98-2

RTECS: UB7700000

Fraction By Weight: 3-5%

ACGIH TLV: 100 PPM RECOMMENDED

TITANIUM DIOXIDE (NOT CONSIDERED A DUST HAZARD IN PAINT)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 2-10%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

VARIOUS PIGMENT (MIXED) (NOT CONSIDERED A DUST HAZARD IN

Fraction By Weight: 0-5%

OSHA PEL 15 PPM

ACGIH TLV: 10 PPM

<250 G/L

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:CURRENTLY NO EVIDENCE OF ADVERSE
EFFECTS RESULTING FROM ROUTINE EXPOSURE. OVEREXPOSURE: HIGH VAPOR
CONCENTRATIONS MAY CAUSE DROWSINESS OR LIGHT-HEADEDNESS. REPORTS
ASSOCIATE REPEATED/PROLONGED OVEREXP OSURE TO SOLVENTS WITH
PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. CONCENTRATING & INHALING
VAPORS MAY BE HARMFUL OR FATAL.

First Aid:EYE: IMMED FLUSH W/WATER. REMOVE CONTACT LENSES, FLUSH
W/WATER 15 MIN, LIFTING EYELIDS. SEE DR ASAP FOR IMMED FOLLOW UP
TREATMENT. SKIN: RINSE W/SOAP & WATER 5 MIN. IMMED REMOVE & DISCARD
CONTAM CLOTH . MAT'L DIFFICULT TO REMOVE WHEN CURED.SEE DR IF IRRIT
OCCURS AFTER WASHING. INHAL: REMOVE TO FRESH AIR IMMED IF IRRIT
OCCURS. GIVE OXYGEN/ARTIF RESP IF REQ'D. INGEST: IF CONSCIOUS, NOT
CONVULSING **

Flash Point Method:PMCC
Flash Point:166F,74C
Lower Limits:0.96 @ 93C
Upper Limits:7.59 @ 93C
Extinguishing Media:INORGANIC DRY CHEMICAL EXTINGUISHING COMPOUNDS,
CARBON DIOXIDE, HIGH-EXPANSION CHEMICAL FOAM. *
BY WT
Fire Fighting Procedures:FIRE FIGHTERS WEAR FULL EMERG EQUIP W/SCBA &
PROTECT CLOTH. CNTNRS MAY DEVELOP PRESSURE & BURST W/HEAT. MOVE
CNTNRS FROM FIRE AREA. COOL CNTNRS W/WATER/FOAM.
Unusual Fire/Explosion Hazard:MATERIAL MAY FOAM (INTUMESCE) SEVERELY
UPON HEATING AND LOSS OF SOLVENT DURING EXPOSURE TO FLAMES.

Spill Release Procedures:ELIMINATE IGNITION SOURCE. PLACE LEAK CNTNR IN
VENTED AREA. WEAR PROTECT CLOTH & BREATH APPARATUS. CONFINE SPILL &
ABSORB ON SAND, SAWDUST, EARTH, OTHER SOLIDS. DIKE TO PREVENT
ENTRANCE INTO WATER SYS /TABLE. SWEEP & PLACE ABSORBED MAT'L
INCNTNR.

Handling and Storage Precautions:COMBUSTIBLE. KEEP AWAY FROM HEAT,
SPARKS, OPEN FLAMES. DO NOT BREATHE VAPORS. KEEP CONTAINERS CLOSED
WHEN NOT IN USE. KEEP AWAY FROM CHILDREN.
Other Precautions:DO NOT TAKE INTERNALLY. AVOID CONTACT WITH SKIN. WASH
THOROUGHLY AFTER HANDLING.

Respiratory Protection:NIOSH/MSHA RESPIRATOR FOR ORGANIC VAPORS (TC23C
OR EQUIV) REQ'D DURING OPEN HANDLING & STANDARD APPLIC. FULL-FACE,
AIR SUPPLIED RESPIRATOR MAY BE NECESSARY FOR EXTENSIVE SPRAY APPLIC
OR FOR PERSONS PA RTICULARLY SENSITIVE TO ODORS/CHEMICALS.
Ventilation:USE LOCAL EXHAUST FANS TO MAINTAIN EXPOSURE BELOW TLV.
MINIMUM 10 AIR-CHANGES/HOUR RECOMMENDED. HANDLE WITH VENT ONLY.
Protective Gloves:BUTYL RUBBER, NITRILE, LATEX, PVC GLOVES
Eye Protection:PROTECT GLASSES, GOGGLES, FULL FACE SHLD
Other Protective Equipment:AS MAY BE NECESSARY TO PREVENT EXCESSIVE
SKIN CONTACT.
Supplemental Safety and Health
KEY1:F8.

HCC:V4
Boiling Pt:B.P. Text:150 TO 165C
Vapor Pres:<20 @25C
Vapor Density:5 - 8
Spec Gravity:1.14 TO 1.26
Solubility in Water:NEGLIGIBLE
Appearance and Odor:WHITE (OR TINTED) OPAQUE LIQUID WITH CHARACTERISTIC
ODOR.
Percent Volatiles by Volume:15-20*

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, WATER, AMINES, ALCOHOLS, STRONG BASES. DO NOT STORE
OR TRANSFER USING COPPER ALLOYS OR ALUMINUM.
Stability Condition to Avoid:DO NOT STORE OR USE IN AREAS WITH OPEN
SOURCES OF IGNITION.
Hazardous Decomposition Products:COMBUSTION PRODUCTS CAN INCLUDE CARBON
OXIDES, NITROGEN OXIDES, AND HYDROGEN CHLORIDE.

Waste Disposal Methods:INCINERATE SOLIDIFIED WASTE OR BURY IN A
SUITABLE, APPROVED LANDFILL.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.